Hold Down Fixture

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Joe Harger
Thermwood Sales
Posts: 34
Joined: Thu, Aug 23 2007, 8:48AM
Location: Thermwood

Re: Hold Down Fixture

Postby Joe Harger » Fri, Jun 22 2012, 10:05AM

Yes we have used this matting material plenty of times here at Thermwood with great results as Brad's video shows. The 3x11 parts should be easy to do as long as pocket chambers/blind holes in mat are drilled in
corresponding locations to your parts, as we have even done much smaller parts then this with good results. A note though, the material we provide has the perfect feel/compression/texture to give good results. You shouldnt expect results from "any" mat that you find at a local store/supplier unless it is indeed similar to the one we provide.



Joe Harger
Software Support
Thermwood Corporation

Daniel Odom
Senior Member
Posts: 204
Joined: Thu, Oct 20 2011, 12:52PM
Company Name: Carlton Kitchen and Bath
Country: UNITED STATES

Re: Hold Down Fixture

Postby Daniel Odom » Fri, Jun 22 2012, 12:10PM

Sounds good, thanks for the info.


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 3 guests