error: appropriate start point?

[Jim Carter]

when I nest the loaded parts in x or y direction I get the following error message.
"Error appropriate start point for outline opperation 12 on panel not found.

this is on my desk top , then when I go to Write CNC I get the following error.
Encountered an improper argument.

any body know how to fix these errors?

thanks

[Brad McIntosh]

Jim,

Can you also include (upload) a copy of the source of the job? Was it a TWD or a layered DXF?

[Jim Carter]

Yes Brad
attached is the TWD file, extension was changed from TWD to txt.

thanks