when I nest the loaded parts in x or y direction I get the following error message.
"Error appropriate start point for outline opperation 12 on panel not found.
this is on my desk top , then when I go to Write CNC I get the following error.
Encountered an improper argument.
any body know how to fix these errors?
thanks
error: appropriate start point?
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Junior Member
- Posts: 61
- Joined: Mon, Nov 30 2009, 3:51PM
- Company Name: Jim Carter Corp.
error: appropriate start point?
- Attachments
-
- ControlNest5-68.zip
- (77.85 KiB) Downloaded 325 times
-
- Guru Member
- Posts: 559
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: error: appropriate start point?
Jim,
Can you also include (upload) a copy of the source of the job? Was it a TWD or a layered DXF?
Can you also include (upload) a copy of the source of the job? Was it a TWD or a layered DXF?
-
- Junior Member
- Posts: 61
- Joined: Mon, Nov 30 2009, 3:51PM
- Company Name: Jim Carter Corp.
Re: error: appropriate start point?
Yes Brad
attached is the TWD file, extension was changed from TWD to txt.
thanks
attached is the TWD file, extension was changed from TWD to txt.
thanks
- Attachments
-
- 12-3-16 teeters.txt
- (146 KiB) Downloaded 336 times