Hi, new here and working with a new Thermwood router over the last week.
A few days ago I tried to set up a wireless adapter to the control unit so that I could remotely send files from my office PC to the router, and to allow technical help if needed.
When running the setup CD, a prompt came up asking for a Thermwood Technician password. The only password I'm aware of is the generic one I was told about during the router installation. I tried it, lowercase and uppercase, and it didn't go through. Tried it blank, nothing.
Anyone seen this before and have any suggestions?
Password prompt on control unit
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- New Member
- Posts: 6
- Joined: Thu, May 10 2012, 3:53PM
- Company Name: American Stonecast
- Country: UNITED STATES
Re: Password prompt on control unit
Michael, try thmtech.....that should work for you
Joe Harger
Software Support
Thermwood Corporation
Joe Harger
Software Support
Thermwood Corporation
-
- New Member
- Posts: 6
- Joined: Thu, May 10 2012, 3:53PM
- Company Name: American Stonecast
- Country: UNITED STATES
Re: Password prompt on control unit
That worked, thanks.