Version 5.05 Controller

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

User avatar
Michael RA Greschuk
Senior Member
Posts: 109
Joined: Mon, Jun 20 2005, 9:00PM
Location: Calgary Alberta

Version 5.05 Controller

Postby Michael RA Greschuk » Thu, May 24 2012, 4:23PM

Now that Thermwood does not offer support for anything older than Windows 2000 Build 9 can control nesting V5.59 be installed on an older controller?
Thank You,
Mike

Daniel Vonderheide
Thermwood Team
Posts: 358
Joined: Wed, May 17 2006, 11:25AM
Location: Thermwood

Re: Version 5.05 Controller

Postby Daniel Vonderheide » Tue, May 29 2012, 8:50AM

Version 5.59 Patch 2 can be installed on THM version 5.05. You will not be able to install any version higher than that unless you upgrade the controller.

User avatar
Michael RA Greschuk
Senior Member
Posts: 109
Joined: Mon, Jun 20 2005, 9:00PM
Location: Calgary Alberta

Re: Version 5.05 Controller

Postby Michael RA Greschuk » Tue, May 29 2012, 5:34PM

Thank you for your response Daniel! We have every intention of upgrading our controller. I was just wondering if I could update rolling nest when we power up our machine.
Mike


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 2 guests