Flycutting Program

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

John Tortorello
New Member
Posts: 11
Joined: Fri, Dec 30 2005, 8:40AM
Company Name: Commercial Millwork Inc
Location: 221 west division streetSyracuse,NY

Flycutting Program

Postby John Tortorello » Thu, Oct 25 2012, 4:57AM

I had a strange thing happen yesterday,
After running parts yesterday, I decided to flycut the waste board, when I loaded the program I noticed that It had been over written with the last program I ran (see attached).
Can anybody explain to me what happened?
Can someone send me a copy so I can replace it?

THM_Flycut.NC MSM.txt
(7.39 KiB) Downloaded 214 times

Joe Harger
Thermwood Sales
Posts: 34
Joined: Thu, Aug 23 2007, 8:48AM
Location: Thermwood

Re: Flycutting Program

Postby Joe Harger » Thu, Oct 25 2012, 9:35AM

I have talked to and sent new Flycut program

Joe Harger
Software Support

Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 2 guests