problem between Thermwood Supercontrol version 7.6.4 desktop and Thermwood Supercontrol version 7.4.8.10 installed at the router.
when I write a cnc program at the desk top and try to run it at the machine I get the following error " Invalid AFL Statement"
line before, at and after ( in this order) are,
If [recut_sheet =1[] then
[CLSQCP]
Setqcppos0
several months ago I had this problem and was instructed to insert the line "THM_Version_override=7.4.8.10" under settings in Machine.ini file the directory Rolling nest on my c drive.
I did this on both computers so when I would sync the machine to the desk top I would not loose that setting.
both machine INI files contain this line now, but since I upgraded control nesting versions I have been having this problem.
Thanks for any responses.
Jim
Invalid afl statement
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Junior Member
- Posts: 61
- Joined: Mon, Nov 30 2009, 3:51PM
- Company Name: Jim Carter Corp.
-
- Junior Member
- Posts: 61
- Joined: Mon, Nov 30 2009, 3:51PM
- Company Name: Jim Carter Corp.
Re: Invalid afl statement
the sollution was given to me by Danial V.
the newest version of control nesting 5.73 address this issue with a setting under the edit menu.called "Thermwood Software Version Overide"
thanks Dan.
Jim
the newest version of control nesting 5.73 address this issue with a setting under the edit menu.called "Thermwood Software Version Overide"
thanks Dan.
Jim
-
- Thermwood Team
- Posts: 361
- Joined: Wed, May 17 2006, 11:25AM
- Location: Thermwood
Re: Invalid afl statement
Always glad to help.