Anyone using Featurecam or Solidcam?

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Forrest Chapman
eCabinets Beta Tester
Posts: 1231
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Anyone using Featurecam or Solidcam?

Post by Forrest Chapman »

Again this is not an attempt to start a discussion here about either of these cam programs but I do have some questions about them. I am most likely going to work full time for another company who will also be leasing my shop for 1 shift a day. This will allow our company to continue at a smaller level on another shift. We will focus on only our best products which require almost no time on my part. The other company has solidworks and is looking to buy either solidcam or featurecam. I will be tasked with learning and implementing the software so if anyone has or is using it to post code to there Thermwood please PM me when you have time. Thanks, Forrest
Post Reply