Z AXIS

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Theo van den Berg
New Member
Posts: 2
Joined: Wed, Mar 27 2013, 8:07AM
Company Name: Moduform
Country: SOUTH AFRICA

Z AXIS

Postby Theo van den Berg » Wed, Mar 27 2013, 9:31AM

I Have re laoded the v7 software after my power supply bomded out, now after I have relaoded the software again and checked the tool lenth censor and set up the waste board,I have a problem. As soon as I want to run the flycut the machine only drops with 10mm and then runs the program. There seems to be a setting I am missing with relation to the daylight and the actual waste board. Please help. Theo

Joe Harger
Thermwood Sales
Posts: 34
Joined: Thu, Aug 23 2007, 8:48AM
Location: Thermwood

Re: Z AXIS

Postby Joe Harger » Wed, Mar 27 2013, 9:49AM

Hello, if you can give us a call at 1800-533-6901 and ask for programming, we can figure out what may be causing issue. This forum is not regularly monitored by Thermwood personnel so the fastest way to solve your problem is to contact us directly.

Joe Harger
Software Support


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 4 guests