Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Zach Froble
Senior Member
Posts: 171
Joined: Tue, Jun 21 2005, 3:23PM
Location: Connellsville, PA


Postby Zach Froble » Thu, Apr 04 2013, 6:04PM

I ran into a project that I would like to use the puzzle joints on. Everything looked fine in ecabs, but when I loaded it in CN the puzzle joints are not showing up. It will cut the outlines on the rails but no pockets. Is there something that needs set up at the machine?


Lyndan Designs
Machining and CAD Services

Joe Harger
Thermwood Sales
Posts: 34
Joined: Thu, Aug 23 2007, 8:48AM
Location: Thermwood


Postby Joe Harger » Fri, Apr 05 2013, 8:12AM

Zach, if you can send an Export file from Control Nesting to program@thermwood.com we can take a look at it to see what could be the issue. Calling in to Thermwood or using the program@thermwood.com email is
going to be the fastest way to receive a reply, as this forum is not regularly monitored by Thermwood personnel.

Joe Harger
Software Support
Thermwood Corporation

Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 4 guests