I ran into a project that I would like to use the puzzle joints on. Everything looked fine in ecabs, but when I loaded it in CN the puzzle joints are not showing up. It will cut the outlines on the rails but no pockets. Is there something that needs set up at the machine?
Thanks,
ZachF
PUZZLE JOINTS
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Senior Member
- Posts: 171
- Joined: Tue, Jun 21 2005, 3:23PM
- Location: Connellsville, PA
PUZZLE JOINTS
Lyndan Designs
Machining and CAD Services
Machining and CAD Services
Re: PUZZLE JOINTS
Zach, if you can send an Export file from Control Nesting to program@thermwood.com we can take a look at it to see what could be the issue. Calling in to Thermwood or using the program@thermwood.com email is
going to be the fastest way to receive a reply, as this forum is not regularly monitored by Thermwood personnel.
Joe Harger
Software Support
Thermwood Corporation
going to be the fastest way to receive a reply, as this forum is not regularly monitored by Thermwood personnel.
Joe Harger
Software Support
Thermwood Corporation