Flip Parts in CN 5.74
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Guru Member
- Posts: 341
- Joined: Sat, Mar 10 2007, 7:31PM
- Company Name: Top Notch Cabinets
- Country: CANADA
- Location: Oakville, Ontario
- Contact:
Flip Parts in CN 5.74
I am getting flip operations on a G2S parts that only have machining operations on one side. Is anyone else getting the same thing. The issue started with CN 5.74. The same cabinet was run on 5.73 with no issue. I've attached it to the post. The pocket on the drawer fronts are machined as flip.
- Attachments
-
- U03 B 76x 17x 36 7-8.zip
- (802.5 KiB) Downloaded 415 times
Top Notch Cabinets
http://www.topnotchcabinets.com/
http://www.topnotchcabinets.com/
-
- Thermwood Team
- Posts: 361
- Joined: Wed, May 17 2006, 11:25AM
- Location: Thermwood
Re: Flip Parts in CN 5.74
Georgi,
You have the two lower drawer slabs in a group with the upper drawer front. This upper drawer front has drill holes on the back side of it. Because they are grouped and there is machining on both sides of the parts in the group, Control Nesting is setting the pockets as the flip operation instead of the drill holes. If you ungroup the parts, they nest without any flip operation.
You have the two lower drawer slabs in a group with the upper drawer front. This upper drawer front has drill holes on the back side of it. Because they are grouped and there is machining on both sides of the parts in the group, Control Nesting is setting the pockets as the flip operation instead of the drill holes. If you ungroup the parts, they nest without any flip operation.
-
- Guru Member
- Posts: 341
- Joined: Sat, Mar 10 2007, 7:31PM
- Company Name: Top Notch Cabinets
- Country: CANADA
- Location: Oakville, Ontario
- Contact:
Re: Flip Parts in CN 5.74
Can I delete my post? Haha.
Daniel, sorry for wasting your time.
Daniel, sorry for wasting your time.
Top Notch Cabinets
http://www.topnotchcabinets.com/
http://www.topnotchcabinets.com/