Hey guys,
installed CN5.75 yesterday, and this morning nested a job and all barcode label for offcuts were showing a -1 as the number. Now the offcut are numbered properly and showing up in the added sheets correctly. just not printing the barcode properly.
Problem got resolved by reverting back to CN5.74. Dont know if anyone of you guys encountered that problem. Included a .PDF showing the problems
Thanks
Dave
Barcode Label Wrong with CN5.75
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- New Member
- Posts: 20
- Joined: Tue, Mar 30 2010, 6:20PM
- Company Name: Silver Creek Cabinetry
- Country: CANADA
- Location: Welland
- Contact:
Barcode Label Wrong with CN5.75
- Attachments
-
- thermwood labels.pdf
- (1.12 MiB) Downloaded 430 times
-
- Junior Member
- Posts: 26
- Joined: Thu, Jan 02 2014, 5:46PM
- Company Name: Northwest Kitchen Centre
- Country: CANADA
Re: Barcode Label Wrong with CN5.75
Having the same issue here.
Isn't there a fix that doesn't involve reverting back to a previous version.
Isn't there a fix that doesn't involve reverting back to a previous version.
-
- Guru Member
- Posts: 559
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: Barcode Label Wrong with CN5.75
Gentlemen...
It appears that an issue with Offfall (off-cut) labels and a missing barcode was resolved, amongst a couple of other changes/fixes, in Control Nesting version 5.76 that was released last September.
Please check the COntrol Nesting Updates page to review all the recent changes and to download the latest version.
Control Nesting Updates
Hope this helps...
It appears that an issue with Offfall (off-cut) labels and a missing barcode was resolved, amongst a couple of other changes/fixes, in Control Nesting version 5.76 that was released last September.
- Offfall barcode missing on labels. (FIXED)
Please check the COntrol Nesting Updates page to review all the recent changes and to download the latest version.
Control Nesting Updates
Hope this helps...