radius curves on more or less than 90

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Thom Davies
Guru Member
Posts: 530
Joined: Tue, May 17 2005, 6:44PM
Company Name: Dawn Group
Country: NEW ZEALAND
Location: Christchurch New Zealand

radius curves on more or less than 90

Post by Thom Davies »

Hey how's it all going?

I was wondering if was possable to put a radius on a shelf with a camfer on it. cos if its on an angle i find the curve wont line up with the line and there would be a step there

Thanks inadvance

Thom Davies
David Hall
eCabinets Beta Tester
Posts: 593
Joined: Tue, May 17 2005, 12:41PM
Location: Stamford, CT USA
Contact:

Post by David Hall »

I'd try a three point arc.
David Hall
Hall's Edge Inc.
eCabinets Machining Services
http://www.HallsEdge.com
Thom Davies
Guru Member
Posts: 530
Joined: Tue, May 17 2005, 6:44PM
Company Name: Dawn Group
Country: NEW ZEALAND
Location: Christchurch New Zealand

Post by Thom Davies »

Thanks David i'll give that a go !

Thanks
Thom Davies
Post Reply