Hello,
We were running our C40 today and the operator hit the E-stop in the middle of a M99 operation. Now the machine will not home, and it is giving an error message of "Z axis has exceeded following error limit"
I have tried powering down and checking all the z axis connections. No issue found there. Any advice?
Thanks
Z axis issue
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- New Member
- Posts: 3
- Joined: Thu, Dec 19 2013, 6:26PM
- Company Name: Westin-Nielsen
- Country: UNITED STATES
-
- Guru Member
- Posts: 559
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: Z axis issue
I would suggest calling or emailing Thermwood's Technical Service Department..
Technical Service: 1-800-221-3856
service@thermwood.com
They should be able to help you.
Technical Service: 1-800-221-3856
service@thermwood.com
They should be able to help you.
-
- New Member
- Posts: 3
- Joined: Thu, Dec 19 2013, 6:26PM
- Company Name: Westin-Nielsen
- Country: UNITED STATES
Re: Z axis issue
Ended up being the 12V 1A pico fuse on the motherboard. Replaced the +12V, then the -12V fried 3 days later. I suggest if anybody else runs into this, that they buy more than 1 fuse. I did just as a precaution if I screwed up installing it, and was lucky to have the second one.