CNC Cutters

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Marius Gouws
Junior Member
Posts: 82
Joined: Sun, May 14 2006, 4:01AM
Company Name: Plett Roofing
Country: SOUTH AFRICA
Location: Plett, South Africa
Contact:

CNC Cutters

Post by Marius Gouws »

Good afternoon.
Anybody from South Africa still hanging around on this forum? If so, where do you get your cutters from? Leuco has take over the Onsrud sales in SA, but if you contact them to order cutters they do not even understand the term up-cut or downcut. They have one! diamond cutter in this hole country.
Thanks in advance.
Marius
jason galbraith
Senior Member
Posts: 249
Joined: Wed, Dec 10 2008, 3:29PM
Company Name: Eastcoast Ultimate
Country: AUSTRALIA
Contact:

Re: CNC Cutters

Post by jason galbraith »

Sounds like a market opening for a knowledgeable tools salesperson over there.
Core i7-2600 @ 3.70Ghz - 8 GB ram - Win 7 Ultimate 64bit - 2 x 24" ASUS monitors - Nvidia 600 Quadro 1GB graphics
www.eastcoastultimate.com.au
Neville Bastian
Guru Member
Posts: 622
Joined: Fri, May 20 2005, 6:48PM
Company Name: Classic Cabinetry
Location: Albany Western Australia
Contact:

Re: CNC Cutters

Post by Neville Bastian »

Hey Jason you better not write that advert.
I have had a few tools work for me over the years but not sure if they would make good cutter salesman?
Marius best of luck with a better source of product supply. We have paid high dollars for tooling over the years to find a lower cost one out performs it by over half.
Regards

Neville
Neville Australia
Post Reply