Need a small change to "cut small to large" setting

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Forrest Chapman
eCabinets Beta Tester
Posts: 1231
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Need a small change to "cut small to large" setting

Post by Forrest Chapman »

This is the most evident when cutting dovetail drawers. In most cases we have it set smallest to largest because of the mix of drawer sizes. The initial skin pass would run so much faster if it ignored the outline setting and made the shortest moves. Ironically this seems to be the way the rest of the operations work.

Forrest
Post Reply