We have a shop that uses KCD to draw their kitchens and would like us to cut their parts. Is there anyone that could give us some guidance on how to go about doing this? We have never cut parts that were generated in this program and would appreciate any info that you may have.
Thanks.
Has anyone cut KCD files on their router?
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
Scott Marshburn
- Guru Member
- Posts: 837
- Joined: Sat, Mar 05 2011, 7:29AM
- Company Name: Heritage WoodWorks
- Country: UNITED STATES
- Location: Jacksonville Nc
- Contact:
Has anyone cut KCD files on their router?
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
-
Mike Murray
- New Member
- Posts: 21
- Joined: Thu, May 22 2014, 10:07AM
- Company Name: VCSS
- Country: UNITED STATES
Re: Has anyone cut KCD files on their router?
Scott,
I believe you would have to have the kcd link to our machine. I am sure there are other workarounds depending on the files kcd puts out.
Good luck,
Mike
I believe you would have to have the kcd link to our machine. I am sure there are other workarounds depending on the files kcd puts out.
Good luck,
Mike