Hello,
I was running some material this afternoon on our CS40 5X10. The sheet is 61 X 120 and was added that way. Someone else had changed the nesting parameters to upper right. The machine began to cut and went into error when it reached the upper right end. I am going to assume it went out of limit. We had this issue before and I was able to change one of the limits and then never had that problem again. With the retro to Qcore done something may have changed it back.
What I am asking, is there any easy way to adjust the limit so that I can finish cutting this part and I don't have to throw away the material. I still have it on the machine and I don't want to move it.
Thanks in advance
Steve
limits on table
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Junior Member
- Posts: 80
- Joined: Wed, Jul 20 2005, 7:29AM
- Company Name: Silhouette Custom Cabinets
- Country: CANADA
- Location: Hamilton, Ontario
-
- Guru Member
- Posts: 559
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: limits on table
Steve,
Someone from CNC Automation's Service Department will try and contact you about this as soon as possible.
Let me know via email if you do not hear from them in the next little while.
Someone from CNC Automation's Service Department will try and contact you about this as soon as possible.
Let me know via email if you do not hear from them in the next little while.