limits on table

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Steve Detina
Junior Member
Posts: 80
Joined: Wed, Jul 20 2005, 7:29AM
Company Name: Silhouette Custom Cabinets
Country: CANADA
Location: Hamilton, Ontario

limits on table

Post by Steve Detina »

Hello,

I was running some material this afternoon on our CS40 5X10. The sheet is 61 X 120 and was added that way. Someone else had changed the nesting parameters to upper right. The machine began to cut and went into error when it reached the upper right end. I am going to assume it went out of limit. We had this issue before and I was able to change one of the limits and then never had that problem again. With the retro to Qcore done something may have changed it back.

What I am asking, is there any easy way to adjust the limit so that I can finish cutting this part and I don't have to throw away the material. I still have it on the machine and I don't want to move it.

Thanks in advance

Steve
Brad McIntosh
Guru Member
Posts: 559
Joined: Wed, May 18 2005, 6:59PM
Company Name: CNC Automation
Country: CANADA
Location: St. Zotique, Québec, Canada
Contact:

Re: limits on table

Post by Brad McIntosh »

Steve,

Someone from CNC Automation's Service Department will try and contact you about this as soon as possible.

Let me know via email if you do not hear from them in the next little while.
Brad McIntosh
CNC Automation

Home: http://www.cncautomation.com
Twitter: @bmcncautomation
Post Reply