I was wondering if there are aggregates shown on the Thermwood site as I cant see any listed. I have a MTR model so I would like to know what is available for my model. I was hoping for a saw that will cut at a 45 and 135 degree angle in the X and Y axis if there is such a thing. Only need to cut 7mm deep. If any user is doing this already would be interested on its good and bad points.
Regards
Neville
aggregates shown on site
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Guru Member
- Posts: 622
- Joined: Fri, May 20 2005, 6:48PM
- Company Name: Classic Cabinetry
- Location: Albany Western Australia
- Contact:
aggregates shown on site
Neville Australia