aggregates shown on site

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Neville Bastian
Guru Member
Posts: 622
Joined: Fri, May 20 2005, 6:48PM
Company Name: Classic Cabinetry
Location: Albany Western Australia
Contact:

aggregates shown on site

Post by Neville Bastian »

I was wondering if there are aggregates shown on the Thermwood site as I cant see any listed. I have a MTR model so I would like to know what is available for my model. I was hoping for a saw that will cut at a 45 and 135 degree angle in the X and Y axis if there is such a thing. Only need to cut 7mm deep. If any user is doing this already would be interested on its good and bad points.

Regards

Neville
Neville Australia
Post Reply