Discuss Thermwood 3-axis Machinery, Controller, and Software.
1 post • Page 1 of 1
- New Member
- Posts: 3
- Joined: Tue, Sep 14 2010, 9:22AM
- Company Name: Talbot Wood Produts
- Country: CANADA
In control nesting I am using a csv (because xls are loading) to cut parts. I had to set my ramp length to 0.1 because the it was ramping out starting with the start of the ramp in, and leaving a tab on every part. I am unable to find a ramp out setting, or a way to disable it.
Who is online
Users browsing this forum: No registered users and 4 guests