control nesting 5.91 ramp issue

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Ryan Vanderkooy
New Member
Posts: 3
Joined: Tue, Sep 14 2010, 9:22AM
Company Name: Talbot Wood Produts
Country: CANADA

control nesting 5.91 ramp issue

Postby Ryan Vanderkooy » Mon, Jun 27 2016, 4:01PM

In control nesting I am using a csv (because xls are loading) to cut parts. I had to set my ramp length to 0.1 because the it was ramping out starting with the start of the ramp in, and leaving a tab on every part. I am unable to find a ramp out setting, or a way to disable it.

Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 7 guests