Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Dave Burtchell
Junior Member
Posts: 98
Joined: Thu, Jun 30 2005, 10:04PM


Postby Dave Burtchell » Mon, Nov 14 2016, 10:52PM

Can I use the edge bander marks on labels with Rhino or is that only available with eCabinets?

With the Qcore upgrade, does a c40 then become a "smart router"?


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 3 guests