Typewriter changer

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Terry Davis
Senior Member
Posts: 168
Joined: Thu, Oct 11 2007, 7:33PM
Company Name: Penn Laminates
Country: UNITED STATES
Location: Trafford PA
Contact:

Typewriter changer

Postby Terry Davis » Tue, Jan 31 2017, 11:36AM

Hi all, yesterday I contacted tech support because we are getting a "ATH changer arm took to long to extend" error, after a sensor adjustment it seemed to work for awhile then the error starting happening with all the arms. this occurs after the arm swings into place before the head even begins to move. I had just started cutting a 28 sheet kitchen so i moved all the bits to the bar to get the job cut. Any ideas on where to begin?

Terry Davis
Senior Member
Posts: 168
Joined: Thu, Oct 11 2007, 7:33PM
Company Name: Penn Laminates
Country: UNITED STATES
Location: Trafford PA
Contact:

Re: Typewriter changer

Postby Terry Davis » Tue, Jan 31 2017, 2:15PM

Sorry, its a 2007 CS45..


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 4 guests