Discuss Thermwood 3-axis Machinery, Controller, and Software.
2 posts • Page 1 of 1
- Senior Member
- Posts: 174
- Joined: Thu, Oct 11 2007, 7:33PM
- Company Name: Penn Laminates
- Country: UNITED STATES
- Location: Trafford PA
Hi all, yesterday I contacted tech support because we are getting a "ATH changer arm took to long to extend" error, after a sensor adjustment it seemed to work for awhile then the error starting happening with all the arms. this occurs after the arm swings into place before the head even begins to move. I had just started cutting a 28 sheet kitchen so i moved all the bits to the bar to get the job cut. Any ideas on where to begin?
Who is online
Users browsing this forum: No registered users and 14 guests