Typewriter changer

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Terry Davis
Senior Member
Posts: 179
Joined: Thu, Oct 11 2007, 7:33PM
Company Name: Penn Laminates
Country: UNITED STATES
Location: Trafford PA
Contact:

Typewriter changer

Post by Terry Davis »

Hi all, yesterday I contacted tech support because we are getting a "ATH changer arm took to long to extend" error, after a sensor adjustment it seemed to work for awhile then the error starting happening with all the arms. this occurs after the arm swings into place before the head even begins to move. I had just started cutting a 28 sheet kitchen so i moved all the bits to the bar to get the job cut. Any ideas on where to begin?
Terry Davis
Senior Member
Posts: 179
Joined: Thu, Oct 11 2007, 7:33PM
Company Name: Penn Laminates
Country: UNITED STATES
Location: Trafford PA
Contact:

Re: Typewriter changer

Post by Terry Davis »

Sorry, its a 2007 CS45..
Post Reply