control nesting bug involving square off fall

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Thomas strembitsky
Guru Member
Posts: 293
Joined: Fri, Jul 27 2012, 12:30PM
Company Name: true form cabinets
Country: CANADA
Contact:

control nesting bug involving square off fall

Post by Thomas strembitsky »

in control nesting load a job with a few pieces on the sheet that will leave a big off fall then nest the job. then go to edit ----> nesting parameters and check off make off fall square. doesn't do anything even if you nest the job again x or y.
every other setting seems to work like nesting start point and collars.
Intel(R) Core(TM) i5-6400 @ 2.70GHz 8.00 GB RAM
NVIDIA GeForce GTX 950
Windows 10 Professional 64-bit
http://www.trueform.ca
CS43 cnc
Clint Buechlein
Thermwood Team
Posts: 696
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: control nesting bug involving square off fall

Post by Clint Buechlein »

Thomas,

Can you post an export from Control Nesting? Mine seems to be operating correctly so I'd like to see what settings you have different than I do.

-Clint-
Thomas strembitsky
Guru Member
Posts: 293
Joined: Fri, Jul 27 2012, 12:30PM
Company Name: true form cabinets
Country: CANADA
Contact:

Re: control nesting bug involving square off fall

Post by Thomas strembitsky »

here you go
there is a cab file in the zip folder only way I could attach it. I can make a video if you need as well
Attachments
control nesting export.zip
(114.56 KiB) Downloaded 399 times
Intel(R) Core(TM) i5-6400 @ 2.70GHz 8.00 GB RAM
NVIDIA GeForce GTX 950
Windows 10 Professional 64-bit
http://www.trueform.ca
CS43 cnc
Clint Buechlein
Thermwood Team
Posts: 696
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: control nesting bug involving square off fall

Post by Clint Buechlein »

Thomas,

Got it sorry. Helps if I read your post better. Missed the part where you said go to Edit, rather than going into Settings, then Nesting Parameters. Sorry for wasting some of your time. We will get it listed and fixed.

-Clint-
Thomas strembitsky
Guru Member
Posts: 293
Joined: Fri, Jul 27 2012, 12:30PM
Company Name: true form cabinets
Country: CANADA
Contact:

Re: control nesting bug involving square off fall

Post by Thomas strembitsky »

no problem. I just found out about doing it this way as its a bit of a time saver
Intel(R) Core(TM) i5-6400 @ 2.70GHz 8.00 GB RAM
NVIDIA GeForce GTX 950
Windows 10 Professional 64-bit
http://www.trueform.ca
CS43 cnc
Post Reply