Nesting Errors

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Mark Hesketh
Guru Member
Posts: 365
Joined: Fri, Aug 25 2006, 9:12AM
Company Name: Paris Kitchens
Country: CANADA
Location: Paris, ontario

Nesting Errors

Postby Mark Hesketh » Tue, Dec 12 2017, 9:31AM

Our machine operator just came in with a problem with nesting his next job. Control Nesting won't let him nest anything, and spits out the following 2 errors:
- No Current Record
- Internal Application Error

Any ideas?

Mark Hesketh
Guru Member
Posts: 365
Joined: Fri, Aug 25 2006, 9:12AM
Company Name: Paris Kitchens
Country: CANADA
Location: Paris, ontario

Re: Nesting Errors

Postby Mark Hesketh » Tue, Dec 12 2017, 10:05AM

Just to update...

I ran the latest Control Nesting update, and those error messages seem to have disappeared... to be replaced with a brand new one

CN Error Message 12-12-2017.jpg


this comes up when you select a .twd to "load", but not if you select a .twd to "add"

then it comes up again when you try to nest the job, and you have to cancel out of the nesting process. But then when you try to nest again, it works fine.

This happens with old jobs as well as new ones. That error message also pops up when you try to "clear all" in the job entry screen.

So we now have an awkward way of working around it, but obviously not working the way it should.

Any advice is welcome :?

Clint Buechlein
Thermwood Team
Posts: 191
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: Nesting Errors

Postby Clint Buechlein » Tue, Dec 12 2017, 2:09PM

You can try going into Settings of Control Nesting and choosing the Clean button. That may get it corrected. See screenshot below.

Clean.JPG


-Clint-


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 6 guests