control nesting 6.06
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Guru Member
- Posts: 293
- Joined: Fri, Jul 27 2012, 12:30PM
- Company Name: true form cabinets
- Country: CANADA
- Contact:
control nesting 6.06
I just noticed this when you open control nesting and go to settings > nesting parameters there is a new "group" box at the bottom but it is greyed out and unclick able. but if you open control nesting and then go edit > nesting parameters the box works.
side note it would be really nice to be able to pick the amount of zeros displayed after the decimal. for some reason in metric it doesn't take the direct number you punch in and I don't need 4 places behind the decimal for cabinetry work. Intel(R) Core(TM) i5-6400 @ 2.70GHz 8.00 GB RAM
NVIDIA GeForce GTX 950
Windows 10 Professional 64-bit
http://www.trueform.ca
CS43 cnc
NVIDIA GeForce GTX 950
Windows 10 Professional 64-bit
http://www.trueform.ca
CS43 cnc
-
- Thermwood Team
- Posts: 668
- Joined: Tue, May 17 2005, 12:44PM
- Location: Thermwood
Re: control nesting 6.06
Hi Thomas. The group combo box is greyed out when accessing the Nesting Parameters from the Settings dialog. The group setting is determined on the Settings dialog when using that method to access Nesting Parameters. When using the Edit menu to access the Nesting Parameters, the group combo box is enabled (not greyed out) so it can be used to make the group settings determination.
We'll look into adding that setting for metric decimal numbers. Thanks!
We'll look into adding that setting for metric decimal numbers. Thanks!