Hey guys and gals,
I have had my CS-43 for about 8 years or so and it has been working great. Few hiccups here and there but otherwise all good. Now I am having an issue with final trimming.
The issue basically is that when the 1\2 inch cutting bit ramps in on the X-Axis, all is good. Now, when it goes to ramp in on the Y-Axis, it cuts the piece just fine. When it goes to trim to final size and ramps in once again and does not trim half of the front edge. So there is a 2mm difference in depth at the front of the part from back to front.
Any input will be good because right now my guys have to trim everything down on the panel saw which is costing time. Which I don't have the luxury to spare.
CS-43 Not trimming to final size
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- New Member
- Posts: 4
- Joined: Fri, Jun 01 2018, 2:59PM
- Company Name: Valley Kitchens Ltd
- Country: CANADA
-
- Guru Member
- Posts: 559
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: CS-43 Not trimming to final size
Tom,
What are you using to create and then generate code for your parts/nests? I seem to recall you are using Microvellum. Is this still the case?
Contact us here at CNC Automation, and we can help look into it with you.
----------------------------------------------------------------------------------------
In Canada Only...
Software Support Questions??
Email us at software@cncautomation.com
or
Call us @ 1-800-421-5955 and ask to speak
with a software support representative.
----------------------------------------------------------------------------------------
What are you using to create and then generate code for your parts/nests? I seem to recall you are using Microvellum. Is this still the case?
Contact us here at CNC Automation, and we can help look into it with you.
----------------------------------------------------------------------------------------
In Canada Only...
Software Support Questions??
Email us at software@cncautomation.com
or
Call us @ 1-800-421-5955 and ask to speak
with a software support representative.
----------------------------------------------------------------------------------------
-
- New Member
- Posts: 4
- Joined: Fri, Jun 01 2018, 2:59PM
- Company Name: Valley Kitchens Ltd
- Country: CANADA
Re: CS-43 Not trimming to final size
Yes, we are still using microvellum for all nest/coding
-
- New Member
- Posts: 4
- Joined: Fri, Jun 01 2018, 2:59PM
- Company Name: Valley Kitchens Ltd
- Country: CANADA
Re: CS-43 Not trimming to final size
I am chatting back and forth with Alain but I wanted to ask on here as well, just in case someone has had the same issue prior.
-
- New Member
- Posts: 4
- Joined: Fri, Jun 01 2018, 2:59PM
- Company Name: Valley Kitchens Ltd
- Country: CANADA
Re: CS-43 Not trimming to final size
Just posting an update here, Alain and I are currently working on the solution, seems to be a bad bearing in the head.
Cheers, Tom
Cheers, Tom