Becker BRD-60 Cyclonic Filter

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Neville Bastian
Guru Member
Posts: 622
Joined: Fri, May 20 2005, 6:48PM
Company Name: Classic Cabinetry
Location: Albany Western Australia
Contact:

Becker BRD-60 Cyclonic Filter

Post by Neville Bastian »

I was wondering if anyone has purchased Becker Cyclonic Filter? Whats the thoughts? Waste of time or worthwhile. They say it prolongs the life of the knives.
Just seems very small and maybe a K & N type filter would work better? The cost at $1000 Aus or $800 US is high.

Also as I have 2 VTLF250 pumps I was wondering has anyone got a similar set up and what Diameter is the PVC pipe you have. Mine is a single 120mm O/D that feeds the two pumps. A machinery salesman, not from Thermwood thought it was too small . Just trying to check if he right.

Regards

Neville
Neville Australia
Post Reply