Part issues

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Jacob Janzen
New Member
Posts: 17
Joined: Mon, Jul 30 2018, 9:37AM
Company Name: California Closets
Country: UNITED STATES

Part issues

Post by Jacob Janzen »

I've been having some issues where when I run a job with a csv Parts List, it occasionally does not drill some parts properly. It does not do the flip operation correctly, nor the drilling. However, when I run the problem parts individually it does them correctly. This is getting to be very annoying as we are wasting time and material. I do not understand why it runs correctly on it's own, but will get messed up as part of a batch.

Any ideas?

Thanks is advance!
Clint Buechlein
Thermwood Team
Posts: 696
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: Part issues

Post by Clint Buechlein »

Jacob,

The hardest part about this is catching it in the act (so to speak). To know exactly what is going on we would need repeatability. Our best chance at that, we would need the CSV you loaded in, the DXFs, an export from Control Nesting, the CNC code itself, and if it is several sheet job, which sheet it was on to help narrow where to look.

-Clint-
Post Reply