Hi Guys
Is this happening to any one else?
We’re using control nesting 6.07
1 load job
2 loaded material list comes up. just accept (OK)
2 nest x or y
3 go to settings Via settings icon (Don’t do anything or do something doesn’t matter)
4 click OK
Setting dialog closes and returns to Control Nesting, It tries to recalculate but gets stuck. (spinning wheel)
The only way out is to close the control nesting non-responding program.
To stop it happening, its best to close control nesting then reopen, don't load any job, open settings check or do whatever you have to do then reload the job.
Thanks
Mark
Control nesting to settings glitch or not question
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Guru Member
- Posts: 507
- Joined: Thu, Jun 16 2005, 7:53PM
- Location: Sydney Aust
-
- Thermwood Team
- Posts: 696
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Control nesting to settings glitch or not question
Mark,Mark McCallum wrote:Hi Guys
Is this happening to any one else?
We’re using control nesting 6.07
1 load job
2 loaded material list comes up. just accept (OK)
2 nest x or y
3 go to settings Via settings icon (Don’t do anything or do something doesn’t matter)
4 click OK
Setting dialog closes and returns to Control Nesting, It tries to recalculate but gets stuck. (spinning wheel)
The only way out is to close the control nesting non-responding program.
To stop it happening, its best to close control nesting then reopen, don't load any job, open settings check or do whatever you have to do then reload the job.
Thanks
Mark
Next version of Control Nesting should have this corrected. Should be this week when we release.
-Clint-
-
- Guru Member
- Posts: 507
- Joined: Thu, Jun 16 2005, 7:53PM
- Location: Sydney Aust
-
- Thermwood Team
- Posts: 696
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Control nesting to settings glitch or not question
Mark,
Today's release of Control Nesting should correct this. Link to install http://www.thermwood.com/updates_contro ... g_home.htm.
-Clint-
Today's release of Control Nesting should correct this. Link to install http://www.thermwood.com/updates_contro ... g_home.htm.
-Clint-