Control nesting to settings glitch or not question

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Mark McCallum
Guru Member
Posts: 507
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Control nesting to settings glitch or not question

Post by Mark McCallum »

Hi Guys
Is this happening to any one else?
We’re using control nesting 6.07
1 load job
2 loaded material list comes up. just accept (OK)
2 nest x or y
3 go to settings Via settings icon (Don’t do anything or do something doesn’t matter)
4 click OK
Setting dialog closes and returns to Control Nesting, It tries to recalculate but gets stuck. (spinning wheel)
The only way out is to close the control nesting non-responding program.


To stop it happening, its best to close control nesting then reopen, don't load any job, open settings check or do whatever you have to do then reload the job.
Thanks
Mark
Clint Buechlein
Thermwood Team
Posts: 696
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: Control nesting to settings glitch or not question

Post by Clint Buechlein »

Mark McCallum wrote:Hi Guys
Is this happening to any one else?
We’re using control nesting 6.07
1 load job
2 loaded material list comes up. just accept (OK)
2 nest x or y
3 go to settings Via settings icon (Don’t do anything or do something doesn’t matter)
4 click OK
Setting dialog closes and returns to Control Nesting, It tries to recalculate but gets stuck. (spinning wheel)
The only way out is to close the control nesting non-responding program.


To stop it happening, its best to close control nesting then reopen, don't load any job, open settings check or do whatever you have to do then reload the job.
Thanks
Mark
Mark,

Next version of Control Nesting should have this corrected. Should be this week when we release.

-Clint-
Mark McCallum
Guru Member
Posts: 507
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Re: Control nesting to settings glitch or not question

Post by Mark McCallum »

Thanks Clint :)
Clint Buechlein
Thermwood Team
Posts: 696
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: Control nesting to settings glitch or not question

Post by Clint Buechlein »

Mark,

Today's release of Control Nesting should correct this. Link to install http://www.thermwood.com/updates_contro ... g_home.htm.

-Clint-
Post Reply