Part editor problem when machining

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

DanFecteau
eCabinets Beta Tester
Posts: 258
Joined: Tue, May 10 2005, 12:00PM
Location: St-Odilon, Quebec, Canada
Contact:

Part editor problem when machining

Postby DanFecteau » Fri, Jan 27 2006, 8:38AM

When I nest in eCab I clearly see my pattern on my top stretcher front but in the rolling nest I don't have anything, and the machine does't rout it so why ?? Thanks
Attachments
test_serrure.esj
(179.99 KiB) Downloaded 79 times

Josh Meyer

Postby Josh Meyer » Fri, Jan 27 2006, 2:44PM

Dan,
In order for us to troubleshoot your cabinet we will need the hsf file. If it is an assembly we will need the esa file. These files are saved in the eCabinets folder on the C(root) drive of your computer. You can also put the cabinet/assembly in a room layout and save that job at which point you could send us the esj file. The esj file you have attached to your post is a job file created from a batch of cabinets and the individual cabinet information isn't contained in an esj file saved this way. Sorry about the confusion!


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 9 guests