Rolling Nest and Excell

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Bill OConnell
Senior Member
Posts: 121
Joined: Mon, Jun 13 2005, 12:26PM
Location: Calverton, New York
Contact:

Rolling Nest and Excell

Postby Bill OConnell » Fri, Jan 27 2006, 9:34AM

I was setting up to cut some simple rectangular panels and I thought I would give the Excel spreadsheet approach a try. I called up the example on Rolling Nest and followed it. However when I tried to open the sheet in Rolling Nest the program aborted. I tried it again with the same result. Any ideas?
Attachments
GrussPanels.xls
Here is the Excel file
(13.5 KiB) Downloaded 110 times
Woodworking the Way You Want It

User avatar
Paul Ford
eCabinets Beta Tester
Posts: 632
Joined: Wed, May 18 2005, 1:18AM
Location: Rotorua - NewZealand
Contact:

Postby Paul Ford » Fri, Jan 27 2006, 1:37PM

Hey Bill,
I tried this last week and had the same problem so i reinstalled V4.87 and it all worked fine after that.
Just wondering if the Thermwood guys might be able to change how it works so it works the sheet size off the name off the sheet stock? Rather than typing in the size off the board it is already saved in rolling nest isnt it?

Josh Meyer

Postby Josh Meyer » Fri, Jan 27 2006, 2:50PM

Bill,
I also had no problems loading and nesting your excel example list. I am running verison 4.87. If you aren't running that version you should download the update from http://www.thermwood.com.


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 5 guests