Vacuum pump malfunction
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Senior Member
- Posts: 158
- Joined: Fri, Apr 10 2015, 7:57AM
- Company Name: Bergman Custom Casework LLC
- Country: UNITED STATES
Vacuum pump malfunction
Just wondering if anyone else had had an issue with their pump dragging on startup. I have the Busch pump that was sold with our machine and it will drag until it pops the breaker on the first startup of the day. If I turn the vacuum switch on the CNC table ON, THEN start the pump (so it is pulling through the spoil/table board) it will fire up every time. It will restart if its been on even for just a minute or two at some point during the shift. Ambient temps are always between 65-70F, and the pump is operating on OEM synthetic oil. I wonder if there is a bleeder valve or something under the table that is not functioning properly. The Motor for the pump tests within parameters and the filter is clean and connections are tight.
_____________
Win 10 Pro 64 bit on MSI Z390M Pro4
Intel core i7 9700KF 3.6GHz (OC 4.2Ghz)
32 gig RAM, NVIDIA GeForce GTX 1050 Ti
NVME SSM2HD 1TB NTFS
Win 10 Pro 64 bit on MSI Z390M Pro4
Intel core i7 9700KF 3.6GHz (OC 4.2Ghz)
32 gig RAM, NVIDIA GeForce GTX 1050 Ti
NVME SSM2HD 1TB NTFS
-
- eCabinets Beta Tester
- Posts: 1119
- Joined: Tue, May 10 2005, 9:36PM
- Company Name: Corlane Custom Cabinetry LLC
- Country: UNITED STATES
- Location: Carnesville, GA
- Contact:
Re: Vacuum pump malfunction
Without opening the vacuum ports, it's like trying to crank a car while it is in gear. We always open the vacuum ports on the table before starting the pumps - in our case, they will pop the breaker every time if we don't. It's much better to start the motor under as little load as possible, which you do by opening the ports for as much free airflow as possible.
http://www.corlanecabinetry.com
Intel Core i7-5820 3.3GHz, 16GB RAM, NVidia Quadro K2200 4GB, Windows 8.1 Pro 64 bit
CS-41 4x8
CS-45 5x12
Intel Core i7-5820 3.3GHz, 16GB RAM, NVidia Quadro K2200 4GB, Windows 8.1 Pro 64 bit
CS-41 4x8
CS-45 5x12
-
- New Member
- Posts: 2
- Joined: Mon, Oct 13 2014, 8:19PM
- Company Name: Spalted Hawthorn
- Country: UNITED STATES
Re: Vacuum pump malfunction
Jeremy, that certainly makes sense, and that's the protocol for doing it from here on out. I agree it likely will prolong the lifetime of the unit. It just seemed strange to me that we had been doing it the other way for so long and then suddenly it would not work that way. An industrial sparky I know said that perhaps one of the windings was failing, but I had the motor tested (used a Meg'r?) and it tested fine. Time will tell, I'm sure. I just wanted to see if there was a hivemind solution that I hadn't thought of yet.