Pocket ramp in

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Joe Soto
Guru Member
Posts: 352
Joined: Thu, May 19 2005, 7:50PM
Company Name: Fancyridge Wood Products LLC
Location: Greensburg, Ky

Pocket ramp in

Postby Joe Soto » Thu, Jun 11 2020, 8:09AM

Cutting pockets using spiral path with a 1 1/2' cutter set to 72% step over.
I have Dado/Rout ramp in setting set to 6" but for some reason I get several parts that the plunge happens on the shortest line possible. It appears to be starting in the step over not the actual rout. I've slowed it feed rate down but even at 15IPM its still a pretty hard plunge since its getting applied to the pre-ramp move and the next motion is at 600IPM. Any suggestion?

Sample code. This one did the ramp in on a 0.03" line
G00X85.8438Y42.5150 (Pocket Rout)
G00Z0.3750
G01Z-0.0020F15.00
G01X85.8438Y42.4850Z-0.1550F600
G01X85.8438Y42.5150Z-0.1550F600
G01X90.3738Y42.5150Z-0.1550F600
G01X90.3738Y42.4850Z-0.1550F600

Joe

Forrest Chapman
eCabinets Beta Tester
Posts: 1164
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Re: Pocket ramp in

Postby Forrest Chapman » Thu, Jun 11 2020, 4:03PM

I get this occasionally if the part is rotated. Not sure what the solution is though.

Forrest


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 26 guests