X axis out

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Ian Richardson
Junior Member
Posts: 64
Joined: Fri, Feb 15 2013, 5:21PM
Company Name: Millworx
Country: CANADA

X axis out

Postby Ian Richardson » Wed, Aug 05 2020, 12:06PM

I think I know what the problem is but I just thought I would ask.
As you can see by my pic. x axis is off. Drive belts are still in tact.
Wont come out of e stop
Thermwood c43

Ian Richardson
Junior Member
Posts: 64
Joined: Fri, Feb 15 2013, 5:21PM
Company Name: Millworx
Country: CANADA

Re: X axis out

Postby Ian Richardson » Wed, Aug 05 2020, 12:22PM

the pic.....
Attachments
x axis off2.jpg
x axis off2.jpg (38.08 KiB) Viewed 495 times

Clint Buechlein
Thermwood Team
Posts: 493
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: X axis out

Postby Clint Buechlein » Wed, Aug 05 2020, 12:40PM

If you go to Maintenance, PLC, PLC Screen, what reason does it say for estop? You can press NC Reset to clear the screen to see what errors are persistent in the event something else was in there that has been corrected.

-Clint-

Ian Richardson
Junior Member
Posts: 64
Joined: Fri, Feb 15 2013, 5:21PM
Company Name: Millworx
Country: CANADA

Re: X axis out

Postby Ian Richardson » Wed, Aug 05 2020, 1:25PM

Yes. Have to remember to check plc history :wall: turns out it was a pop up pin. Thanks to Simon @ CNC Automation. Resolved
Thanks for the reply though Clint :beer:

Clint Buechlein
Thermwood Team
Posts: 493
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: X axis out

Postby Clint Buechlein » Thu, Aug 06 2020, 9:02AM

Ian Richardson wrote:Yes. Have to remember to check plc history :wall: turns out it was a pop up pin. Thanks to Simon @ CNC Automation. Resolved
Thanks for the reply though Clint :beer:


Glad you were able to get it fixed.

-Clint-


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 15 guests