Discuss Thermwood 3-axis Machinery, Controller, and Software.
2 posts • Page 1 of 1
- Junior Member
- Posts: 34
- Joined: Sat, Jan 14 2006, 3:32PM
- Location: New Orleans
today my 40hp table vaccum was making a very loud grinding noise and i took a look at it and the turbine is binding up/grinding in the turbine housing. just trying to see if anyone has heard of this before and how to fix it? right now i am looking at it and it is fine until i put the cover on the last side. it looks to me that the bearings hold the blades in the turbine in the right place. I believe that there is to much play in the shaft b/c i can get it to stop grinding until i put the last cover on it. just need to know if there is an adjustment i am missing. thanks in advance.
Cabinets and Countertops of Louisiana
Who is online
Users browsing this forum: No registered users and 2 guests