Router Guys

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Forrest Chapman
eCabinets Beta Tester
Posts: 1231
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:

Router Guys

Post by Forrest Chapman »

Hi All,

Just want to inform everyone about something my uncle has made for us. It is basicaly a 10mm shank tool collet for anyone using a 5, 8, 10, 20, 32, or 40 mm tool with a 10mm shank and set screw. The only alternative that I've found is a tool holder specificaly made for this which cost about $350.00 or so. This part fits in a standard 3/4 or 19mm collet and will cost only 25 to $30.00. Not sure on the cost yet because I don't know how many will be in the first order. If your interested you can respond to this message or email me at forrestchapman1@yahoo.com

Thanks
Forrest
Post Reply