Discuss Thermwood 3-axis Machinery, Controller, and Software.
3 posts • Page 1 of 1
- Junior Member
- Posts: 34
- Joined: Sat, Jan 14 2006, 3:32PM
- Location: New Orleans
when i nest a job it shows me what sheets i have etc i print them out so i know what it is cutting on what sheet. then i go to sheet six on this particiular jod and it is back panels to the cabinets and it it giving me drilling operations. it should only be doing two dados then outlining the pieces. also when i select a sheet it says that the call label doesn't exist. tks in advance.
Cabinets and Countertops of Louisiana
Who is online
Users browsing this forum: No registered users and 3 guests