Printing labels

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

User avatar
Thom Davies
Guru Member
Posts: 530
Joined: Tue, May 17 2005, 6:44PM
Company Name: Dawn Group
Country: NEW ZEALAND
Location: Christchurch New Zealand
Contact:

Printing labels

Postby Thom Davies » Tue, Mar 28 2006, 9:25PM

Hey how's it going?

A while ago there was a post about labels. One idea was that it printed the sheet and the labels for that sheet as it was cutting that sheet. Any news about that?

Thanks

Thom Davies.
[url=http://www.colinmcraesport.com]
Image
[/url]

Ryan Hochgesang
Thermwood Team
Posts: 681
Joined: Wed, May 18 2005, 8:41AM
Location: Thermwood

Postby Ryan Hochgesang » Wed, Mar 29 2006, 8:45AM

Thom,

When printing Sheets and labels, the system starts with Sheet one.

I hope this answers your question. I'm not really sure what your asking here.
Ryan Hochgesang
Software Support

User avatar
Thom Davies
Guru Member
Posts: 530
Joined: Tue, May 17 2005, 6:44PM
Company Name: Dawn Group
Country: NEW ZEALAND
Location: Christchurch New Zealand
Contact:

Postby Thom Davies » Wed, Mar 29 2006, 2:38PM

Hey Ryan

Sorry i didn't explain enough. I run jobs that sometimes have over 40 sheets in a single nest. It would really save time and money if RN could print out the labels and the print out for that sheet as it's cutting that sheet out. E.g running sheet 25 and have the labels and print out for sheet 25 being printed as it's being cut. Rather than printing all the labels for the 40+ Sheets and all the print outs which can take up to 1.5 hours some times.

Thanks

Thom Davies
[url=http://www.colinmcraesport.com]
Image
[/url]


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 2 guests