I am shopping for a router and software, I have looked at pretty much
everything out there and have some questions about processing with thermwood.
I have a 10,000ft shop 5 men 70% commercial 30% residential all frameless const. We also have a nitch in wood storefronts
would like to talk to someone out there that is using thermwood for processing,nesting imparticular
nesting opperation
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Wizard Member
- Posts: 5852
- Joined: Thu, Jul 28 2005, 10:18AM
- Company Name: Dan Epps
- Country: UNITED STATES
- Location: Rocky Face GA
Bill
Two members that come to mind quickly are David Hall (you may have seen the article about him in CabinetMaker magazine) and Forrest Chapman. Both have websites where you can see some of their work.
You can find their websites by looking for their names in the member list and clicking on the link button. You can also send them email or private messages from there.
Two members that come to mind quickly are David Hall (you may have seen the article about him in CabinetMaker magazine) and Forrest Chapman. Both have websites where you can see some of their work.
You can find their websites by looking for their names in the member list and clicking on the link button. You can also send them email or private messages from there.
-
- eCabinets Beta Tester
- Posts: 979
- Joined: Thu, May 19 2005, 10:50PM
- Location: Los Alamos, CA
-
- eCabinets Beta Tester
- Posts: 386
- Joined: Tue, May 10 2005, 5:23AM
- Location: Lancaster, NH
- Contact: