Groovey

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

User avatar
Thom Davies
Guru Member
Posts: 530
Joined: Tue, May 17 2005, 6:44PM
Company Name: Dawn Group
Country: NEW ZEALAND
Location: Christchurch New Zealand
Contact:

Groovey

Postby Thom Davies » Mon, Apr 10 2006, 11:34PM

Hey how's it going?

I have this cabinet here and it has grooves on the top and the deck. In ecab nest the grooves show up but down at the RN it doesn't show up.
RN is 4.91

Thanks

Thom Davies.
[url=http://www.colinmcraesport.com]
Image
[/url]

User avatar
Jason Susnjara
Thermwood Team
Posts: 1722
Joined: Tue, May 10 2005, 1:26PM
Location: Thermwood
Contact:

Postby Jason Susnjara » Tue, Apr 11 2006, 7:41AM

Hi Thom,

Because you have part editor cuts on this cabinet, the software is wanting to pocket the dados out. Also your dados or cuts are about 7 to 8mm right? I have added a pic to show what to change. You will need to change the tool diameter for the Pocket Tool Setup to a tool that is smaller than the cuts that you made. I then nested the parts again and the dados show up which is the other image. Hope this makes sense. I am getting ready to look at your flip op prob.

thanks,
Attachments
pockettoolsetup.jpg
pockettoolsetup.jpg (174.72 KiB) Viewed 538 times
nestpocket.JPG
nestpocket.JPG (126.93 KiB) Viewed 538 times


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 2 guests