Piggy Back drill bank
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Guru Member
- Posts: 828
- Joined: Fri, Jun 17 2005, 12:23AM
- Location: South Africa
Piggy Back drill bank
I have a 9 spindle drill bank on my Cabinet Shop 40 and have only managed to get it to drill one hole at a time. COuld some one tell me what the exact requirements/settings are in Rolling Nest to get this thing to drill multiple holes. Thermwood promised a fix end last week but this has not materialised and I am sitting with a very fancy looking and expensive attachment on my machine. I know it did work and have seen them work on other machines and I just want to make sure that I am not missing something. I do suspect however it has something to do with the latest patches to Rolling Nest.
There was an issue between eCab V4.08 and the V4.57 Control Nesting software that has been corrected with the new release of V4.09 eCabinet Systems. You can do the eCabinet software update by going to the Communications option at the top tool bar in the eCab software, and selecting Web Update. Once you,ve done the update rewrite your twd file with the updated software and then take it to the machine to nest. If you are still having issues, please contact us at Thermwood ( 1800 221 3865).
-
- Guru Member
- Posts: 828
- Joined: Fri, Jun 17 2005, 12:23AM
- Location: South Africa
Hi Ryan
Been there done that got the T shirt but no holes. The patch does not in fact sort out the issue that is why I am asking for you to enumerate the exact setup requirements in case I am missing something. By the way your metric / American Imperial bug in the collar setting is still not fixed.
Cheers
Nick
Been there done that got the T shirt but no holes. The patch does not in fact sort out the issue that is why I am asking for you to enumerate the exact setup requirements in case I am missing something. By the way your metric / American Imperial bug in the collar setting is still not fixed.
Cheers
Nick
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
Hi Nick,
Can you email me your machine.ini and tools.thm which are located in the C:/Rolling Nest folder on the controller. Then if you can send me the eCabinet job and twd file, and I will take a look at it.
My email is: cabinets@thermwood.com
thanks,
Can you email me your machine.ini and tools.thm which are located in the C:/Rolling Nest folder on the controller. Then if you can send me the eCabinet job and twd file, and I will take a look at it.
My email is: cabinets@thermwood.com
thanks,
-
- Thermwood Team
- Posts: 1721
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact: