Anyone using or has used Cut Planner?

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Sebastien Boileau
Junior Member
Posts: 98
Joined: Wed, Jun 22 2005, 9:15PM
Location: Orleans, Ontario
Contact:

Anyone using or has used Cut Planner?

Postby Sebastien Boileau » Fri, Jun 09 2006, 9:47AM

I'm looking into getting it but the only site i found was in England....Was wondering if anyone has used it or is using it, i'd like to know how well it works.

Rick Palechuk
Wizard Member
Posts: 1896
Joined: Wed, May 18 2005, 7:54PM
Company Name: Milltech Millworks Ltd.
Country: CANADA
Location: Edmonton, Alberta
Contact:

Postby Rick Palechuk » Thu, Jun 29 2006, 9:37PM

Hi Sebastien, is that a sheet optimizer? If it is, I use Cutmaster 2D and It works ok. It,s real simple, and free. I got it from Bit torrent.

Rick

Rick Palechuk
Wizard Member
Posts: 1896
Joined: Wed, May 18 2005, 7:54PM
Company Name: Milltech Millworks Ltd.
Country: CANADA
Location: Edmonton, Alberta
Contact:

Postby Rick Palechuk » Thu, Jun 29 2006, 9:58PM

Opps. Sorry about that Team I thought I was posting a pm. Will not happen again :oops: .

Rick


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 3 guests