Macro file does not exist

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

eCabinets Beta Tester
Posts: 258
Joined: Tue, May 10 2005, 12:00PM
Location: St-Odilon, Quebec, Canada

Macro file does not exist

Postby DanFecteau » Tue, Jun 20 2006, 10:14AM

When I try to run an easy link job, everything's look ok till I try to start the program at my 2nd sheet, I get program error 3420 \"macro file does not exist\" ???????

Ryan Hochgesang
Thermwood Team
Posts: 681
Joined: Wed, May 18 2005, 8:41AM
Location: Thermwood

Postby Ryan Hochgesang » Tue, Jun 20 2006, 4:10PM

Hi Daniel,

I've reviewed your cnc files and also your machine type, the M901 code is a fixture offset code used on dual table machines. Your machine (according to my records) however is a single table machine and only used the G901 and G902 codes. Therefore when your machine tries to exicute this code, the macro does not exist. This would be due to the Dual Table setting in the SETTINGS of control nesting.

Let me know if you have any questions.
Ryan Hochgesang
Software Support

Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 2 guests